MSI Neo 2 Platinum

[FieryGoose]

I have a Antec Proformance Plus case and there are 2 wires that i can't figure out where they go. the purpose of these wires is two light up the roman numaral 1 light and roman numeral 2 light. The wire ends for these lights very small and have 2 small holes, with roman numeral 1 and 2 written on them. My mobo schematics just is not detialed enough to tell me where these wires would go. If anyone could help me find very detailed schematics for these wires or simply understand and can answer the question i just asked that would be greatly appreciated. Thanks.

 

[FieryGoose]

Alright maybe's i was too confusing or somthing but if someone knew where to find some detailed schematics for the motherboard (i looked at the msi website and i couldn't find anything of use) that would be a great help. :cheers:

 

[FieryGoose]

can anyone help me, im kinda at a stopping point until i get some help?

 

[Dedatorv]

Are you talking about cold cathode neon lights (Like this?) ? Did they come with the case or did you buy them seperately? If they are cold cathode neon lights they need to go into an power inverter(Little black box that may have come with them). The power inverter converts the little wires into the standard 4 molex plug kind.

A picture of the wire could help out a lot.

 

[FieryGoose]

Are you talking about cold cathode neon lights (Like this?) ? Did they come with the case or did you buy them seperately? If they are cold cathode neon lights they need to go into an power inverter(Little black box that may have come with them). The power inverter converts the little wires into the standard 4 molex plug kind.

A picture of the wire could help out a lot.

nah, what im talking about, you can see in the link in my sig, when you enlarge the pic the bottom two lights on the front of my case have there own plugins labled: I and II. They come connected to the hdd led and the power led on the wire part, although they are seperate from them at the pluggin piece, like if you buy new headphones the right and the left speaker wires come connected a little below you chin but if you want them looser you can peel them apart, same thing with the I and II wires. I just don't know where to plug them in to my mobo at. Some help please.

 

[FieryGoose]

i just figured out what they were for at the antec website, they are just additional for devices that require additional led's, like SCSI controllers, RAID and IDE controller, not that i know what those are im just quoting the website.