Slight Problem...

[coLE']

Right... I booted up computer this morning, started up GW:F put password in and boom - monitor went off and " Selt Test, your monitor is working properly" "power saving shall enable" appeared.

This kept happening everytime i reset the comp, and it got a bit further each time. I booted up in safe mode, it seemed to be ok so i assumed it was a driver problem, so uninstalled all the graphics card drivers. Reset the comp again hit F8 again, and tried to start up, reinstalled the drivers and reset again, tried to change the resolution and it only detected up to 900x600 res , so i dunno what to do now, or how to fix this??

Any help much appreciated!! :frown: :bonce:

 

[Asus]

What refresh rate is it set at?

 

[coLE']

Not sure, i remeber setting it to the max when i first installed the drivers in the first place, but when i reinstalled the drivers today in safe mode i set it to 100. Not sure how to check it thoguh..

 

[Barney Fife]

Start system in safe mode again by pressing F8 before windows splash screen comes up and reset your monitor refreshment rate.

Good Luck.

 

[coLE']

OK, i was wondering if a re-format would sort this problem, i was due to do one in a week or so anywayz, think it would work?

Also, how excactly would you reset the monitor refresh rates?